Product ID:ADVANCED CEL POLYESTER COATING, PART A
MSDS Date:07/03/1986
FSC:8010
NIIN:00N082186
MSDS Number: CGCKT

ADVANCED COATINGS & CHEMICALS

4343 TEMPLE CITY BLVD
TEMPLE CITY, CA 91780
US

Emergency Phone: 818-579-6270

Info Phone: 818-579-6270

Cage: ACTAD

ADVANCED PRODUCTS DBA ADVANCED COATINGS & CHEMICAL

TEMPLE CITY, CA 91780-4229 US

Telephone: 818-579-6270

Cage: 51686

POLYESTER RESIN

OSHA PEL N/K

ACGIH TLV: N/K

14801-96-9)

CAS: 1480-96-6

OSHA PEL 10 MG/M3 (MFR)

ACGIH TLV: 6 MG/M3 (MFR)

STYRENE POLYMER; (HYDROCARBON RESIN)

CAS: 9003-53-6

RTECS: WL6475000

OSHA PEL 5 MG/M3 (MFR)

ACGIH TLV: N/K

STYRENE MONOMER; (STYRENE) (SARA 313) (MFR'S INVALID CAS

CAS: 100-42-5

RTECS: WL3675000

OSHA PEL 100 PPM

ACGIH TLV: 50 PPM;100 STEL, S

EPA Report Quantity: 1000 LBS

DOT Report Quantity: 1000 LBS

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:YES OSHA:NO
Health Hazards Acute and Chronic:ACUTE:EYES:CAN CAUSE SEVERE
IRRITATION, REDNESS, TEARING AND BLURRED VISION. SKIN:PROLONGED OR
REPEATED CONTACT CAN CAUSE IRRITATION; DEFATTING.
INHALATION:DIZZINESS, BREATHING DIFFICULTY, HEADACHES A ND LOSS OF
COORDINATION. INGESTION:DAMAGE TO THROAT AND ESOPHAGUS, VOMITING &
DIARRHEA. CHRONIC:EYES: (EFTS OF OVEREXP)
Explanation of Carcinogenicity:STYRENE:IARC MONOGRAPHS, VOL 60, PG 115,
1994:GROUP 2B. ANIMAL:REPRODUCTIVE SYSTEM.
Effects of Overexposure:HLTH HAZ:BLURRED VISION. CONJUNCTIVITIS.
SKIN:SENSITIZATION, DERMATITIS. INHAL:ASTHMA-LIKE SYMPTOMS. CENTRAL
NERVOUS SYSTEM EFFECTS. INGEST:DAMAGE TO THROAT. POSSIBLE KIDNEY &
LIVER IMPAIRMENT. CAN CA USE CHEMICAL PNEUMONITIS & PULMONARY
EDEMA. STYRENE:CAUSES LIVER, KIDNEY & LUNG DAMAGE.
Medical Cond Aggravated by Exposure:ASTHMA, RESPIRATORY TRACT
IRRITATION, DERMATITIS. KIDNEY & LIVER PROBLEMS, CONJUNCTIVITIS.

First Aid:EYES:FLUSH W/LARGE AMOUNTS OF WATER FOR AT LEAST 15 MINUTES.
SKIN:WASH THOROUGHLY W/SOAP & WATER. SEE MD. INHAL:MOVE PERSON TO
FRESH AIR. IF BREATHING STOPS, APPLY ARTIFICIAL RESPIRATION & SEEK
IMMEDI ATE MEDICAL ATTENTION. INGEST:DO NOT INDUCE VOMITING.
CONTACT MD IMMEDIATELY.

Flash Point Method:TCC
Flash Point:98.0F,36.7C
Lower Limits:1.1%
Upper Limits:6.1%
Extinguishing Media:FOAM, DRY CHEMICAL, CO*2 &/OR WATER FOG.
Fire Fighting Procedures:USE NIOSH APPROVED SCBA & FULL PROTECTIVE
EQUIPMENT .
Unusual Fire/Explosion Hazard:DURING FIRE, IRRIT & TOX GASES & SMOKE
ARE PRESENT FROM DECOMP. ISOLATE FROM HEAT, SPKS & OPEN FLAMES.
CLSD CNTNRS MAY BURST WHEN EXPOS TO EXTREME HEAT.(SUPDAT)

Spill Release Procedures:ELIMINATE IGNITION SOURCES; PROVIDE GOOD
VENTILATION; DIKE SPILL AREA & ADD ABSORBENT MATERIAL TO SPILLED
LIQUID. THOROUGHLY WET W/WATER & MIX.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

Handling and Storage Precautions:AVOID HOT METAL SURFACES. USE IN COOL,
WELL-VENTILATED AREAS. KEEP CONTAINERS CLOSED WHEN NOT IN USE. KEEP
AWAY FROM EXCESSIVE HEAT & OPEN FLAMES.
Other Precautions:SMOKING IN AREAS WHERE THIS MATL IS USED SHOULD BE
STRICTLY PROHIBITED. TOOLS USED W/THIS MATL SHOULD BE ALUMINUM,
BRASS/COPPER. PLASTIC TOOLS SHOULD NOT BE USED. SINCE EMPTIED
CNTNRS RETAIN PROD RESI DUES, (VAPS, LIQ &/OR SOLID) ALL(SUPDAT)

Respiratory Protection:WHEN SPRAYING &/OR PRINTING THIS MATL, USE NIOSH
APPRVD CARTRIDGE RESP/GAS MASK SUITABLE FOR AIRBORNE MISTS & VAP
CONCS BELOW TIME-WEIGHTED TLVS. WHEN USING IN POORLY VENTED &
CONFINED SPACES, USE A N IOSH APPRVD FRESH-AIR SUPPLYING (SUPDAT)
Ventilation:GEN MECH VENT/LOC EXHST SHOULD BE SUITABLE TO KEEP VAP CONC
BELOW TLV. VENTILATION EQUIPMENT MUST BE EXPLOSION PROOF.
Protective Gloves:IMPERMEABLE GLOVES.
Eye Protection:ANSI APPROVED CHEM WORKERS GOGGS(SUPDAT)
Other Protective Equipment:ANSI APPRVD EYE WASH FOUNTAIN & DELUGE
SHOWER . USE IMPERMEABLE APRONS & PROT CLTHG WHENEVER POSS TO PVNT
(SUPDAT)
Work Hygienic Practices:NONE SPECIFIED BY MANUFACTURER.
Supplemental Safety and Health
EXPLO HAZ:VAPS FORM EXPLO MIXT IN AIR BTWN UPPER & LOWER EXPLO LIMS.
OTHER PREC:HAZ PRECS SHOULD BE OBSERVED. RESP PROT:RESP/SCBA. EYE
PROT:& FULL LENGTH FACESHIELD . OTHER PROT EQUIP:SKIN CONT. USE OF
HEAD CAPS WHENEVER POSS IS STRONGLY REC. USE NON-SPARKING UTENSILS
WHEN HNDLG THIS MATL.

Boiling Pt:B.P. Text:293F,145C
Vapor Pres:7.5 @ 20C
Vapor Density:HVR/AIR
Spec Gravity:1.11
Evaporation Rate & Reference:FASTER THAN BUTYL ACETATE
Solubility in Water:NEGLIGIBLE
Appearance and Odor:NONE SPECIFIED BY MANUFACTURER.
Percent Volatiles by Volume:26

Stability Indicator/Materials to Avoid:YES
ALKALINE MATERIALS, STRONG ACIDS & OXIDIZING MATERIALS.
Stability Condition to Avoid:EXCESSIVE HEAT, POOR VENTILATION,
CORROSIVE ATMOSPHERE, EXCESSIVE AGING, SPARKS & OPEN FLAMES.
Hazardous Decomposition Products:CARBON MONOXIDE, CARBON DIOXIDE,
OXIDES OF NITROGEN, VARIOUS HYDROCARBON & ACRID FUMES.

Waste Disposal Methods:COLLECT ABSORBENT/WATER/SPILLED LIQUID MIXTURE
INTO METAL CONTAINERS & ADD ENOUGH WATER TO COVER. CONSULT LOCAL,
STATE & FEDERAL HAZARDOUS WASTE REGULATIONS BEFORE DISPOSING INTO
APPROVED HAZARDOUS WA STE LANDFILLS. OBEY RELEVANT LAWS.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.